Broca para martillo Bosch PRO SDS Plus-5X, broca 5x50x110 mm

Bosch PRO SDS Plus-5X, 5 x 50 x 110 mm, is a professional SDS Plus hammer drill bit intended for rotary hammers with SDS Plus chucks. The bit is designed to produce precise 5 mm diameter holes in masonry and concrete for anchors, plugs and fixing tasks. Its shank geometry ensures secure fit in compatible SDS Plus tools and consistent transfer of hammering energy for efficient drilling in hard substrates.

Advantages

The SDS Plus-5X drill bit combines a stable shank connection with a hardened carbide tip to resist wear when working in abrasive materials. Its optimized flute design removes dust effectively from the hole, reducing friction and improving drilling progress. The 5 mm cutting diameter gives accurate hole sizing for standard anchors and fittings, while the overall length provides sufficient drilling depth for typical fixing applications. The bit is suitable for repeated use under professional jobsite conditions and for precise DIY tasks.

Suitable for

• Drilling 5 mm holes in concrete and masonry for anchors and plugs
• Preparing fixing points for screws and bolts in construction and renovation
• Use with SDS Plus rotary hammers for professional and home projects

Key specifications

• Drill diameter: 5 mm
• Working length: 50 mm
• Total length: 110 mm
• Shank type: SDS Plus
• Tip material: carbide
• Recommended materials: masonry, concrete

How to use

Select an SDS Plus rotary hammer compatible with a 5 mm drill bit and insert the Bosch PRO SDS Plus-5X until it locks in the chuck. Mark the drilling position on the substrate and start drilling at low speed to establish a precise entry point, then increase hammer action and pressure as required. Withdraw the bit periodically to clear dust from the hole and maintain drilling efficiency. After reaching the required depth, clean the hole before inserting anchors or plugs.

Recommendations

Use appropriate personal protective equipment — eye protection, hearing protection and dust mask — when drilling. For long continuous work in dense concrete, allow the bit to cool periodically and check the carbide tip for wear. Use the correct anchor or plug size matched to the 5 mm hole for reliable fixing performance.