Brodit MultiMoveClip a placa adaptadora AMPS para DA220 (217036)

Mount a device holder with an AMPS hole pattern onto a Brodit MultiMoveClip mount using this adapter plate. The plate attaches to the MultiMoveClip and provides a 30 x 38 mm AMPS drilling pattern for securing compatible holders. It is used in vehicle installations where a MultiMoveClip mount is already present and a switch to an AMPS-based holder is required.

Key specifications

• Mounting interface (plate side): Brodit MultiMoveClip
• Mounting interface (holder side): AMPS hole pattern, 30 x 38 mm
• Material: High-strength ABS plastic
• Colour: Black
• Adjustability: 360° swivel, approx. 15-20° tilt
• Installation: Screw-on to Brodit ProClip or flat surface
• Included hardware: 4 self-tapping screws for AMPS attachment

Why choose it

The adapter plate allows reuse of an existing MultiMoveClip mount with AMPS-compatible holders, avoiding the need to replace the entire mounting system. The swivel and tilt adjustment helps position the holder for optimal viewing and access.

Ideal use cases

• Converting a Brodit MultiMoveClip mount to accept AMPS device holders
• Vehicle installations where a holder with AMPS pattern must be attached to a MultiMoveClip base
• Fleet or professional setups requiring a standardized AMPS interface

Good to know

The plate is made of vibration-resistant ABS plastic and is suitable for use with DA220 as noted by the manufacturer. It is part of the Brodit MultiMoveClip system.