Brumberg 00003836 Cable de extensión Plug&Play 1m Negro 24V DC

Brumberg’s Plug&Play extension cable solves a common problem in low-voltage LED setups: reaching that awkward distance between driver and luminaire. Unlike soldering or fiddly wire nuts, this factory-made accessory clicks securely into place — a genuine 2-pole male-to-female system that locks with a reassuring snap. The black plastic jacket is both flexible and slim, so you can route it through cable ducts, along suspended ceilings, or under desks without bulk.

Highlights

• 1 metre extension length for Brumberg Plug&Play LED systems
• Original 24V DC rating — perfectly matched to Brumberg drivers
• IP20 protection for indoor use
• Tool-free, polarity-correct plug-in connection
• Black jacket blends with dark ceilings and cable trays

In daily use

Run the cable where your power supply sits out of sight — behind storage, above panels, or inside trunking. The connectors maintain polarity automatically, and the plastic housing protects contacts from accidental touches. Need more than a metre? Just connect multiple extensions in series; every joint stays mechanically stable and electrically safe. This is a genuine Brumberg replacement part, so you know it will fit properly with matching Plug&Play drivers and luminaires.

Full specifications

• Type: Extension cable
• Compatibility: Brumberg Plug&Play
• Length: 1 m (1000 mm)
• Colour: Black
• Poles: 2
• Voltage: 24V DC
• Protection rating: IP20
• Environment: Indoor
• Connector: Plug&Play male to female
• Jacket material: Plastic

Final note

This cable is supplied with the original Brumberg quality guarantee. Use it specifically with Brumberg Plug&Play components; other connection systems are not compatible. For installations requiring a custom length, daisy-chain multiple cables up to the driver’s maximum output.