Cable alargador 3-Pin delgado ProXtend M-M Blanco 10 m (M3S-10W)

ProXtend 3-pin Slim Extension Cable M-M White 10 m (M3S-10W) is a slim male‑to‑male extension cable with three conductors and a 10‑metre length, designed to extend connections between compatible 3‑pin low‑voltage devices. The white jacket and flexible construction allow the cable to be routed neatly in installations with limited space. It is intended for extending signal or low‑power circuits such as LED strips, controllers and similar equipment where a discreet, flexible connector lead is required.

Advantages

The cable’s slim profile and flexible insulation make it easy to pass through narrow channels and behind fittings without adding bulk. Its three-conductor layout provides the common wiring needed for many low-voltage applications while the 10 m length offers extended reach for longer runs. The white outer sheath helps the cable blend into light-coloured interiors and reduces visual impact when routed along walls or ceilings.

Suitable for

• Extending 3‑pin LED strip connections and controllers
• Low‑voltage signal wiring in audio/visual setups
• Connecting small low‑power devices where a slim cable is preferred
• Routing wires in cabinets, behind panels, or along skirting boards

Key specifications

• Three conductors for common low‑voltage signal or power lines
• Male‑to‑male connector configuration
• Length: 10 metres
• Colour: white outer sheath
• Slim, flexible jacket suitable for tight routing
• Net weight approx. 0.4 kg

How to use

Identify the compatible 3‑pin connectors on the devices to be linked and ensure both are powered off before connecting. Plug one male end into the output of the source device and the other male end into the input of the target device, maintaining correct pin alignment. Route the cable so it avoids sharp bends, heat sources and moving parts; secure with clips or ties if necessary. After installation, restore power and verify the connection and device operation.

Recommendations

Use this slim extension cable for short to medium low‑voltage runs where space-saving routing is required; avoid using it for high-current loads and keep within the electrical specifications of the connected devices. For permanent installations, protect exposed sections with appropriate conduit or cable channels and confirm polarity and compatibility before powering.