Cable de alimentación EUROLITE P-Con 1-4 3x2,5mm² — cable divisor de alimentación para suministrar corriente a varios dispositivos

The EUROLITE P-Con 1-4 3x2.5mm² power cable is a mains splitter cable designed to distribute electrical supply from a single inlet to four outputs. It allows safe and organised connection of multiple lighting fixtures or audio devices in event and studio setups. The cable uses a 3x2.5mm² conductor configuration intended for standard mains voltages and offers a compact solution for short-run power distribution where several devices need to be fed from one supply point.

Advantages

This mains splitter cable simplifies power distribution by converting one feed into four outputs without complex wiring. The 3x2.5mm² conductors provide sufficient current capacity for many lighting and audio equipment combinations commonly used in small to medium event rigs and studio environments. Durable insulation and standard connectors help maintain secure connections and reduce the risk of accidental disconnection during setup and operation.

Suitable for

Key specifications

How to use

Connect the single inlet end of the EUROLITE P-Con 1-4 to a properly rated and protected mains supply. Route the four outlet cables to the devices you need to power and connect them to the appropriate mains inlets on each device. Ensure that the combined current draw of all connected devices does not exceed the safe current rating of the supply circuit or the cable run. Arrange and secure the cable to prevent tripping hazards and avoid overbending near the connectors.

Recommendations

Use this splitter for short, temporary installations and verify total load before connecting multiple high-power devices. For permanent installations or where longer runs and higher currents are required, use appropriately rated distribution equipment and consult an electrician. Inspect connectors and insulation before each use and replace the cable if any damage is found.