Cable de alimentación interno ShiverPeaks BS78233-HQ 0,13 m

The ShiverPeaks BS78233-HQ internal power cable is a compact 0.13 m cable designed to deliver power from a Molex 4-pin source to two SATA 15-pin devices. Its short length and standard connectors make it suitable for routing power in confined areas of a PC case while maintaining stable power delivery to hard drives, SSDs, optical drives or other SATA-powered components.

Advantages

This cable provides a straightforward conversion from a Molex 4-pin connector to two SATA 15-pin connectors in a compact 0.13 m form factor, reducing cable clutter and shortening routing paths. The standard connector types ensure broad compatibility with legacy and modern components. Its design supports stable power transfer and simple plug-and-play installation without requiring additional adapters or tools.

Suitable for

• Powering 2.5" and 3.5" SATA hard drives and SATA SSDs in small form-factor builds
• Connecting optical drives or other SATA-powered peripherals where PSU SATA connectors are limited
• Use inside compact PC cases or tight mounting locations where a short cable run is required
• System builds that need conversion from Molex peripheral power to SATA power

Key specifications

• Cable length: 0.13 m (approx.)
• Input connector: Molex 4-pin
• Output connectors: 2 × SATA 15-pin
• Purpose: internal power distribution from Molex to SATA devices
• Form factor: short/compact cable suitable for tight spaces

How to use

Turn off the computer and disconnect the power supply before installing the cable. Plug the Molex 4-pin connector into a compatible Molex peripheral power output from the PSU, then connect the two SATA 15-pin connectors to the target SATA devices. Ensure connectors are fully seated and that cables do not obstruct airflow or block other components. After connections are secure, reconnect power and power on the system to verify device recognition.

Recommendations

Use this short ShiverPeaks internal power cable when you need a tidy, direct power connection in compact cases or close-mounted drive bays. Avoid excessive bending or tension on the connectors; route the cable to prevent strain and ensure adequate ventilation around drives. Do not use the cable to power devices that exceed the current rating of the originating Molex connector or the power supply's available rails.