Cable de alimentación MicroConnect PE100450 5 m, negro, conector hembra C13

MicroConnect PE100450 is a 5 m black power cable with a C13 coupler designed to link equipment with IEC C14 inlets to mains supplies or extension leads. The cable provides extended reach for rack-mounted and desktop devices while maintaining the standard C13 connection widely used across IT and AV equipment.

Advantages

The cable offers a standardized C13 coupler for broad compatibility with servers, PCs, monitors and peripherals. Its 5 m length enables flexible placement of equipment without relocating power sources. The black jacket is unobtrusive in professional environments and helps conceal the cable in racks and cable runs. Construction provides reliable electrical contact and consistent performance for typical mains voltages used with C13/C14 power systems.

Suitable for

• Connecting servers and rack equipment to power distribution units or extension leads
• Powering desktop computers, monitors and office peripherals
• AV devices and small network appliances that accept IEC C13 connections
• Temporary setups where additional reach is needed without modifying infrastructure

Key specifications

• Cable length: 5 m
• Connector type: C13 coupler
• Colour: Black
• Intended use: AC mains power connection for equipment with IEC C14 inlets

How to use

Insert the C13 coupler end of the cable into the C14 inlet on the target device until it seats fully. Connect the opposite end to a compatible power source such as a power distribution unit, mains outlet via a suitable plug or an extension lead. Ensure both ends are secure and routed to avoid strain on connectors; avoid tightly bending the cable near the connector ends. Use the cable only with devices and mains voltages compatible with standard C13/C14 power systems.

Recommendations

For reliable operation, route the cable to minimise exposure to physical damage, avoid running alongside high-heat sources, and secure it in racks or conduits where appropriate. Regularly inspect connector contacts for corrosion or damage and replace the cable if the jacket or connectors are compromised.