Cable de altavoz PSSO LS-15100 2x1,5 mm 10 m Negro

PSSO LS-15100 2x1.5 mm 10 m Black is a two-conductor speaker cable designed to connect loudspeakers to amplifiers, receivers or public address systems. Each conductor has a cross-sectional area of 1.5 mm² and the cable is supplied in a 10 metre length with a flexible outer sheath and clear polarity marking. The construction aims to provide a low-resistance, stable connection for indoor audio installations where moderate run lengths and conductor gauge are appropriate.

Advantages

The cable combines a pair of 1.5 mm² conductors in a single, flexible jacket to permit easy routing in walls, under floors or along skirtings. Its low-resistance copper conductors support reliable signal transmission and the printed or marked polarity on the outer sheath reduces the risk of reversed connections during installation. The 10 m length accommodates typical room-to-equipment distances without the need for splices or additional joins.

Suitable for

Key specifications

How to use

Cut the cable to the required length or use the supplied 10 m length as needed. Strip the outer sheath and insulation from each conductor to expose the copper for termination. Connect the positive and negative conductors to the corresponding speaker and amplifier terminals, observing polarity markings to maintain correct phase. Use appropriate connectors (banana plugs, spade lugs or bare wire) and ensure secure, low-resistance terminations. Route the cable away from power wiring where possible to reduce interference and avoid sharp bends that may damage the conductors.

Recommendations

For best audio performance in longer runs or higher-power systems consider larger conductor cross-sections; for the majority of typical room installations up to 10 m the 1.5 mm² conductors provide adequate conductivity. Store the cable in a dry indoor location and avoid exposure to UV or direct moisture.