Cable de audio LogiLink CA1077 50 m transparente

LogiLink CA1077 is a 50 m audio cable constructed from copper-clad aluminium (CCA) with a transparent outer sheath. Both conductors have a cross-sectional area of 0.75 mm². The cable is intended for connecting audio devices where a long, flexible run is required and comes without fitted connectors, allowing custom termination.

Advantages

The CCA construction provides a balance between conductivity and cost, while the transparent sheath offers visible inspection of the inner conductors and a neutral appearance that integrates into different environments. With 50 m length and flexible insulation, the cable supports long-distance routing and easy installation.

Suitable for

• Connecting speakers and audio components requiring bare-wire terminations
• Long cable runs in home audio setups or small installations
• Custom installations where connectors are fitted on-site

Key specifications

• Length: 50 m
• Conductor material: Copper-clad aluminium (CCA)
• Conductor cross-section: 0.75 mm² (each conductor)
• Connectors: None (bare cable)
• Colour: Transparent

How to use

Cut the cable to the required length and strip the outer sheath and conductor insulation to expose the copper-clad conductors. Terminate the conductors with appropriate connectors (banana plugs, spade lugs, or screw terminals) or solder them directly to the device terminals following polarity conventions. Ensure secure mechanical and electrical connections and avoid sharp bends or kinks along the run.

Recommendations

For optimal performance, keep cable runs as short as practical for the installation, use proper connectors and secure routing to prevent mechanical strain, and avoid running audio cable in parallel with high-voltage power cables to minimize interference.