Cable de audio Omnitronic 3022519D 10 m XLR 3 pines 6,35 mm negro

The Omnitronic 3022519D 10 m audio cable connects equipment with a male XLR (3-pin) connector to devices with a male 6.35 mm (1/4") jack. Constructed for professional audio use, the cable's 10-metre length and black jacket provide reliable reach and discreet appearance on stage, in studios, and at live events. It transmits analog audio signals between microphones, mixers, instruments and other audio hardware while maintaining signal integrity over medium distances.

Advantages

The cable offers a balanced XLR-to-6.35 mm connection suitable for many audio setups, with robust connectors and a durable outer jacket that resist wear during repeated use. At 10 metres, the length balances flexibility and low handling noise, and the straightforward construction supports consistent analog signal transfer with minimal degradation when used as intended.

Suitable for

Key specifications

How to use

Plug the male XLR end into the microphone or device with an XLR female output, and insert the male 6.35 mm jack into the corresponding input on a mixer, amplifier, or instrument input. Ensure connectors are fully seated to prevent intermittent contact. Route the cable to avoid sharp bends, kinks, or pinching, and secure it with cable ties or tape where appropriate to minimize trip hazards and handling noise.

Recommendations

For optimal performance, use this cable for analog, line-level or instrument-level connections within its 10 m length. Avoid running the cable parallel and close to mains power cables to reduce hum and interference. Periodically inspect connector contacts and the jacket for damage; replace the cable if connectors become loose or shielding is compromised.