Cable de audio RCA ShiverPeaks 40110-15 – 2 RCA a 2 RCA, 15 m

The ShiverPeaks 40110-15 is an unbalanced analog audio cable with two RCA connectors at each end and a 15 meter length. It is intended for connecting consumer audio equipment such as amplifiers, CD players, receivers and mixers where RCA inputs and outputs are used. The cable provides a simple, direct signal path for line-level audio between RCA-equipped devices and is suitable for home audio setups and small studio or rehearsal spaces where extended reach is required.

Advantages

The cable’s unbalanced design offers straightforward compatibility with most consumer audio components that use RCA connections. With a 15 m length, it enables flexible placement of devices without requiring additional adapters or extenders. The two RCA-to-two RCA configuration supports left and right stereo channels, delivering a clear and consistent line-level signal transfer for typical audio playback and basic recording applications.

Suitable for

• Connecting CD players, receivers or tuners to amplifiers or powered speakers
• Linking audio interfaces or mixers to consumer-grade playback devices
• Home audio systems requiring longer cable runs between components
• Small studio or rehearsal setups where RCA connections are available

Key specifications

• Connector type: 2 RCA (male) to 2 RCA (male)
• Cable length: 15 m
• Signal type: Unbalanced analog, line level
• Channels: Stereo (left and right)
• Intended use: Consumer audio interconnects for line-level signals

How to use

Connect one end of the cable to the RCA output of the source device (for example a CD player or receiver) and the other end to the RCA input of the destination device (for example an amplifier or powered speaker), matching left (white) and right (red) channels. Ensure both devices are powered off when making connections, then power them on and set appropriate input levels. Keep the cable routed to avoid tight bends and minimize interference from power cables or radiating electronic equipment.

Recommendations

For optimal performance in unbalanced signal paths, avoid routing the cable parallel to mains power lines and keep run lengths as short as practical. Use this 15 m cable where RCA connections are specified; for longer runs or professional balanced setups, consider a balanced cable solution to reduce susceptibility to noise.