Cable de audio ShiverPeaks 40102-1MHQ — 2x RCA a 2x RCA, longitud 1,0 m

ShiverPeaks 40102-1MHQ — 2x RCA to 2x RCA, length 1.0 m is a stereo audio interconnect cable intended for connecting consumer audio components. The cable carries line-level left and right signals between source devices and amplifiers, receivers or powered speakers equipped with RCA inputs. With a 1.0 m length, it is suited for short to medium distance connections in home audio systems, media centers and desktop setups.

Advantages

This audio cable provides reliable analog signal transfer for left and right channels without additional processing. The design uses two matched RCA conductors to preserve channel separation and maintain consistent line-level levels. Its moderate length reduces excess cable slack and potential signal loss in typical home installations. The cable is simple to install and compatible with a wide range of consumer audio equipment that uses RCA terminations.

Suitable for

• Connecting CD players, media players or DACs to amplifiers and receivers
• Linking AV receivers to powered speakers or subwoofers with RCA inputs
• Connecting phono preamps or mixers to stereo inputs on home audio systems
• Short to medium-length connections in home theater or desktop audio setups

Key specifications

• Connector type: 2x RCA male to 2x RCA male
• Function: stereo line-level analog audio transmission (left and right channels)
• Cable length: 1.0 m
• Application: consumer audio / A/V interconnect

How to use

Connect one end of the cable to the source device's left (white) and right (red) RCA outputs and the other end to the corresponding RCA inputs on the amplifier, receiver or powered speaker. Ensure connectors are fully seated to avoid intermittent contact and keep the cable routed away from mains power cables to reduce potential interference. Verify that source and destination devices are powered appropriately and set to the correct input or output modes before playback.

Recommendations

For optimal performance, use the 1.0 m length for setups where the source and destination are within close proximity to avoid unnecessary cable loopbacks. Inspect connectors periodically for oxidation or wear and replace the cable if any connector damage or significant noise appears during playback.