Cable de audio ShiverPeaks BS06-151011 25 m transparente

The ShiverPeaks BS06-151011 25m Transparent audio cable is a long, flexible cable designed for audio and video setups that require extended reach. Constructed from copper-clad aluminium (CCA), the cable balances conductivity and cost-effectiveness while maintaining a transparent outer jacket that allows visual inspection of the conductor. With a 25 m length and neutral appearance, it fits installations where discreet routing and dependable signal transmission are needed.

Advantages

The cable’s copper-clad aluminium conductors provide adequate electrical conductivity for general audio signal transmission while keeping weight and cost lower than pure copper alternatives. The transparent outer jacket resists daily wear and makes it easier to identify cable runs in multi-cable installations. A 25 m length reduces the need for additional extensions and supports flexible placement of audio equipment.

Suitable for

• Home and small studio audio connections
• Temporary event wiring and stage setups
• Routing between equipment racks and wall-mounted units
• Replacement or extension of existing audio cabling where long runs are required

Key specifications

• Cable length: 25 m
• Conductor material: copper-clad aluminium (CCA)
• Outer colour: transparent
• Design: flexible audio cable suitable for long runs

How to use

Measure the required run and lay the 25 m cable along the planned route, avoiding sharp bends and pinch points. Cut to length and terminate each end with the appropriate connector for your equipment, ensuring secure soldering or reliable connector clamping as needed. Test signal continuity and audio quality after termination. For permanent installations, secure the cable with clips or ties at regular intervals to prevent movement and strain on terminations.

Recommendations

For best results, use this cable for line-level audio signals and moderate-length microphone runs; avoid using CCA cable for very long, critical low-level signals where maximum conductivity is required. Keep the cable away from strong electromagnetic sources and high-voltage power lines to reduce the risk of interference.