Cable de conexión de fibra óptica SFP+ compatible con CBO BlueOptics BO353503J30M 30 m para Netgear AXC7630

The SFP+ compatible fiber patch cable BlueOptics BO353503J30M is a 30 m multimode fiber link designed for use with Netgear AXC7630 SFP+ ports. This cable provides a factory-terminated duplex fiber connection suitable for short-range 10GbE links in racks, server rooms and network closets. The product is intended as a replacement or extension cable where direct compatibility with the listed Netgear model is required and where a 30 metre multimode fiber reach is appropriate.

Advantages

The cable offers plug-and-play connectivity for SFP+ interfaces and supports high-speed 10 gigabit Ethernet transmission over multimode fiber. Its pre-terminated duplex connectors ensure consistent optical performance and reduce installation time compared with field-terminated fibers. The 30 m length provides flexible routing in equipment racks and data center aisles while maintaining signal integrity for short-range links.

Suitable for

• Short-range 10GbE interconnects between switches and servers
• Patch connections in networking racks and data centers
• Replacement of factory or OEM fiber patch cables compatible with Netgear AXC7630
• Linking SFP+ transceivers and optical modules in enterprise environments

Key specifications

• Cable type: duplex multimode fiber patch cable
• Connector type: SFP+ compatible duplex optical connectors (pre-terminated)
• Length: 30 metres
• Supported link speed: up to 10 Gigabit Ethernet (10GbE) over short-range multimode
• Typical application: intra-rack and adjacent-rack fiber patching

How to use

Disconnect power to active ports if required by your site procedures, then insert each duplex connector into the corresponding SFP+ port or transceiver until it clicks. Route the cable through cable management channels or ties to avoid sharp bends and to maintain the specified bend radius for multimode fiber. Verify link lights and run appropriate network diagnostics or speed tests to confirm a stable 10GbE connection after installation.

Recommendations

Handle connectors by the boot and avoid touching the fiber endfaces. Keep protective caps on until just before insertion, and clean endfaces with approved fiber-cleaning tools if required. For best performance, use this 30 m multimode patch cable for short-range links within the same equipment room or adjacent racks rather than long-distance trunking.