Cable de consola Cisco CAB-CONSOLE-USB-RFB 1,8 m cable de consola USB para dispositivos Cisco

The Cisco CAB-CONSOLE-USB-RFB 6 ft USB console cable provides a 6-foot USB connection for accessing and managing Cisco networking equipment via a console port. Designed to support direct console sessions, configuration changes, troubleshooting and firmware updates, the cable offers a standard USB interface intended for use with Cisco console adapters and compatible devices. It is intended as a local console access solution for network administrators and IT technicians working with Cisco hardware.

Advantages

This 6 ft USB console cable offers a fixed-length connection that gives sufficient reach for typical rack and bench setups while keeping cable clutter to a minimum. Its standard USB interface ensures compatibility with common console adapter ports on Cisco devices. The cable is designed to support reliable serial console sessions used for device configuration and firmware operations. As a Cisco-branded accessory with the specified MPN and EAN, it is suitable where manufacturer compatibility and clear identification are required.

Suitable for

• Accessing console ports on Cisco routers and switches for configuration
• Troubleshooting and monitoring device boot or runtime output via a serial console
• Applying firmware updates and performing initial device setup
• Local administration in server rooms, network cabinets and workbenches

Key specifications

• Brand: Cisco
• Model / MPN: CAB-CONSOLE-USB=-RFB
• EAN: 5715063465615
• Cable length: 6 ft (approximately 1.8 m)
• Category: USB data cables

How to use

Connect the cable between a host USB port (or a USB-to-serial adapter if required) and the console port on the Cisco device. Open a terminal or serial console application on the host system configured with the appropriate serial parameters for the target device. Use the connection for interactive configuration sessions, issuing commands, monitoring boot messages or transferring firmware as supported by the device. Follow standard device and host operating system procedures for installing any necessary drivers or console utilities.

Recommendations

For stable operation, verify device-specific console settings (baud rate, parity, stop bits) before starting a session and ensure any required drivers for USB console connectivity are installed on the host. Keep the 6 ft cable neatly routed in rack or bench environments to avoid interference with other equipment and to facilitate quick disconnection when servicing devices.