Cable de extensión de red Bachmann 356.910 IEC 60320 C20 a C19 16A 50 cm gris

Power extension cable Bachmann 356.910 IEC 60320 C20 to C19 16A 50 cm grey is a short power lead that provides a standardized connection between C20 inlets and C19 equipment couplers. With a 50 cm length and 16 A rating it is intended for use where a compact, reliable power link is required, such as in server racks, UPS installations and network equipment setups. The grey cable and standardized IEC 60320 connectors ensure compatibility with many high-current devices while minimizing cable clutter in confined spaces.

Advantages

This 50 cm Bachmann lead offers a short, robust connection that reduces excess cabling and improves airflow in racks. The IEC 60320 C20 (male) to C19 (female) configuration supports devices designed for 16 A supply and follows international connector standards for predictable compatibility. The compact length and grey jacket make it practical for close-proximity connections behind servers, UPS modules or power distribution units without creating long cable runs.

Suitable for

• Connecting rack-mounted servers to C20 outlets in data centers
• Linking UPS output to C19 inlet devices in backup power setups
• Powering network switches, PDUs and high-current IT equipment in cabinets
• Short interconnections in office equipment rooms and laboratory racks

Key specifications

• Connector A: IEC 60320 C20 (male)
• Connector B: IEC 60320 C19 (female)
• Current rating: 16 A
• Length: 50 cm
• Cable colour: grey

How to use

Ensure both the power source and connected equipment are switched off before making the connection. Insert the C20 male connector into the corresponding C20 outlet or power distribution unit, and plug the C19 female connector onto the equipment inlet. Verify that the connectors seat fully and that the cable is routed to avoid strain or sharp bends. After installation, power on the source and then the equipment following standard commissioning procedures.

Recommendations

Use this cable for short-distance, high-current connections where a standardized IEC 60320 C20–C19 link is required. Avoid using the lead in environments with excessive moisture, heat, or mechanical abrasion. Regularly inspect connectors and the jacket for damage and replace the cable if any insulation or contact defects appear.