Cable de fibra óptica InfiniBand SFP+ BlueOptics CBL-10GSFP-AOC-1M-BO 1 m conector macho/conector macho

The BlueOptics CBL-10GSFP-AOC-1M-BO is a 1 meter active optical cable (AOC) with SFP+ connectors on both ends designed for 10G data transmission over multimode fiber. It implements the SFP+ form factor according to MSA standards and supports standard 10GBASE-SR optical protocols, enabling direct connections between switches, routers, servers and storage platforms without additional transceivers or patch cords. The cable integrates a transmitter and receiver at each end and provides Digital Diagnostics Monitoring (DDM/DOM) when supported by host hardware.

Advantages

This SFP+ AOC offers high-speed 10 Gbps throughput over a short 1 m multimode link while remaining immune to electromagnetic interference. As a factory-assembled optical link it eliminates the need for field-polished patch cords, reducing insertion loss and simplifying installation. The product is built to MSA specifications with component selection intended to meet common reliability expectations and supports real-time diagnostic data such as supply voltage, laser bias, output and received optical power, and temperature via DDM/DOM when the connected equipment exposes that interface.

Suitable for

Key specifications

How to use

Install the cable by inserting each SFP+ end into a compatible SFP+ port on the two devices to be connected. Ensure devices are powered down or follow hot-plug guidance from the hardware vendor; most SFP+ ports support hot insertion. Confirm the host devices support 10GBASE-SR or SFP+ active optical cables and enable any required port settings in the equipment’s management interface. If DDM/DOM information is needed, verify that the host system exposes diagnostic registers and monitor values through the management or diagnostics tools.

Recommendations

Use this 1 m BlueOptics SFP+ AOC for short-reach connections inside racks or between adjacent racks where a pre-assembled fiber link reduces installation time and potential signal loss. Verify compatibility with the target hardware’s SFP+ ports and enable diagnostic monitoring on supported systems to aid troubleshooting and lifecycle monitoring.