Cable de fibra óptica METZ CONNECT 151P7EAJAA0E SC LC I-V(ZN) H 10 m blanco

The METZ CONNECT 151P7EAJAA0E SC–LC fibre optic cable is a 10 m single‑mode patch cable engineered for reliable optical data transmission in network and telecommunication installations. It uses G.657.A2 fibre, suitable for tight‑radius routing and indoor deployments, and comes in white for discreet integration into cabling paths. Connector types SC and LC provide compatibility with a wide range of networking equipment and patch panels.

Advantages

This fibre cable delivers low attenuation and consistent signal quality across the link, while the G.657.A2 fibre type supports improved bend performance for installations with limited space. The combination of SC and LC connectors offers flexible connection options between equipment with different interface types. The 10 m length balances reach and manageability for rack‑to‑rack, cabinet‑to‑patch panel or workstation connections.

Suitable for

• Indoor network backbone and horizontal cabling
• Patch panels, switches and media converters with SC and LC ports
• Data centres and server rooms requiring tight‑bend fibre routing
• Office and commercial premises where a 10 m reach is required

Key specifications

• Cable length: 10 m
• Cable type: I‑V(ZN) H
• Fibre type: single‑mode G.657.A2
• Core diameter: 9 µm
• Connector A: SC
• Connector B: LC
• Colour: White

How to use

Inspect connectors and ports before insertion to ensure cleanliness and proper alignment. Insert the SC connector into an SC adapter or port with a straight push until it latches; insert the LC connector into an LC adapter or duplex port by aligning the keyed end and pushing gently until it clicks. Avoid twisting or pulling the cable at the connector interface. Route the cable following building cabling practices, maintaining recommended bend radii for G.657.A2 fibre and securing the cable to prevent strain. When disconnecting, press the connector release if present and pull straight out.

Recommendations

Use a fibre cleaning tool or lint‑free wipes with approved solvent to clean endfaces before connection. Maintain bend radius larger than the minimum specified for G.657.A2 where possible, and label both ends for easy identification. For critical links, verify optical loss with a power meter or certification tester after installation.