Cable de jack estéreo de 6,3 mm (1/4 de pulgada) Omnitronic 3021165K, 6 m de longitud

Omnitronic 3021165K is a 6 m stereo audio cable equipped with 6.3 mm (1/4") TRS jack connectors. It is designed to connect instruments, audio interfaces, mixers and outboard equipment where a standard stereo or balanced line connection is required. The cable length provides flexibility for stage, studio and live configurations while maintaining consistent signal transmission across the run.

Advantages

The cable offers a standard 6.3 mm TRS termination that supports stereo or balanced mono signals depending on the connected devices. Its 6 m length reduces the need for extension adapters and helps organize signal routing in performance and recording environments. Omnitronic construction focuses on stable contacts and a sheath that resists handling and movement during live use. The cable delivers low-noise audio transfer when used with compatible equipment and jacks.

Suitable for

Key specifications

How to use

Insert each 6.3 mm TRS jack fully into the corresponding input and output connectors of your instruments, mixer channels or amplifiers. For stereo sources, use the TRS wiring to carry left and right channels; for balanced mono connections, connect to equipment that supports TRS-balanced wiring. Avoid pulling the cable by the cord; instead, grip the connector housings when unplugging. Coil the cable loosely after use to prevent kinks and preserve performance.

Recommendations

For the best signal quality, route the cable away from power supplies and large cable bundles carrying mains current. When using the cable for balanced mono connections, verify that both connected devices support TRS-balanced wiring to achieve noise reduction. Regularly inspect the connectors and sheath for wear and replace the cable if contacts become intermittent.