Cable de red Cat.6A U/UTP fino Equip 0,15 m negro 10000 Mbit/s

The Equip Cat.6A U/UTP Slim Patch Cable 0.15m is a compact network patch cable designed for high-density installations, data centres and enterprise networks. With a slim 32 AWG construction and RJ-45 connectors on both ends, this 0.15 m cable provides 10 Gigabit Ethernet performance up to 500 MHz while occupying minimal space in racks and patch panels.

Advantages

The slim U/UTP design improves cable management and airflow in crowded racks without adding shielding, making it suitable for environments with low to moderate electromagnetic interference. Stranded bare copper conductors and a moulded boot with strain relief ensure flexibility and durability for frequent moves and reconfigurations. The cable is RoHS compliant and available with a Low Smoke Zero Halogen (LSZH/LSOH) jacket for safer operation in enclosed spaces.

Suitable for

• Connecting switches, patch panels and servers in high-density racks
• Short horizontal links in data centres and server rooms
• PoE and PoE+ powered devices such as IP phones and access points

Key specifications

• Standard: Cat.6A U/UTP (UTP), compliant with ISO/IEC 11801 and EN 50173
• Length: 0.15 m
• Conductor: Stranded bare copper, 32 AWG
• Bandwidth/frequency: up to 500 MHz
• Data rate: 10 Gbit/s (10GBase-T)
• Connectors: RJ-45 straight male – RJ-45 straight male
• Jacket: Low Smoke Zero Halogen (LSZH/LSOH)
• Colour: Black
• Compliance: RoHS

How to use

Plug each RJ-45 connector into the corresponding network port on your switch, patch panel or device until the connector clicks into place. Use the cable for short patching runs between equipment in racks or cabinets; because the cable is short and slim, route it along cable management channels to maintain airflow and neatness. Avoid sharp bends and excessive pulling to protect the stranded conductors and the moulded strain relief.

Recommendations

For best performance, use this slim Cat.6A patch cable for short interconnections within racks and patch panels. Avoid high-EMI environments where shielded cabling would be required, and do not exceed manufacturer-recommended bend radii to preserve signal integrity.