Cable de red DELOCK Cat6 SF/UTP (S-FTP) 0,25 m — RJ-45 a RJ-45, negro/azul

DELOCK Cat6 SF/UTP (S-FTP) networking cable, 0.25 m long, equipped with RJ-45 plugs on both ends. The short patch cable is intended for Gigabit Ethernet and high-speed data transmission between network devices such as switches, routers and patch panels. The included waterproof RJ45 set with cable gland allows a watertight seal at the connector and increases protection against weather and mechanical damage for outdoor or exposed installations.

Advantages

The cable supports Cat6 performance with SF/UTP (S-FTP) shielding for reduced interference and stable data transfer. Its 0.25 m length is suitable for short patching in racks or desktop environments. The waterproof RJ45 set provides IP68 dust- and waterproof protection at the connector when properly assembled, improving durability in outdoor or damp locations. The dual-colour design (black/blue) facilitates cable identification and tidy cable runs.

Suitable for

• Short patch connections between switches, routers and network interfaces
• Rack and patch panel installations where short cable runs are required
• Outdoor or semi-exposed connections when the waterproof RJ45 set is fitted

Key specifications

• Standard: Cat6
• Shielding: SF/UTP (S-FTP)
• Connector: RJ-45 to RJ-45
• Length: 0.25 m
• Colour: Black/Blue
• Protection: IP68 at connector with included waterproof set
• Brand: DELOCK, MPN: 66808, EAN: 4043619668083

How to use

Connect the RJ-45 plugs to the respective network ports on your devices. For outdoor or exposed installations, assemble the included waterproof RJ45 set: mount the cable gland onto the threaded coupling of the RJ45 jack and tighten to achieve a watertight seal between the connector and the housing. Verify the connection and test network link speed after installation.

Recommendations

Use the waterproof RJ45 set only as supplied and ensure all seals are tightened correctly to maintain IP68 protection. Avoid sharp bends and excessive tension on the 0.25 m cable to prevent connector strain. For permanent outdoor runs, confirm that adjacent components and housings are rated for outdoor use.