Cable de red DELOCK RJ45 ST < BU con interruptor en línea Cat.6 F/UTP 1 m

DELOCK RJ45 ST < BU network cable Cat.6 F/UTP, 1 m, combines Category 6 transmission performance with a compact inline switch to control a wired Ethernet connection without unplugging. The cable uses a foil-shielded unshielded twisted pair (F/UTP) design to reduce external interference and supports Gigabit Ethernet speeds where Cat6 cabling is required. The ST < BU connector provides a secure RJ45 termination and the integrated inline switch enables manual connection or disconnection of the link for quick switching between networked devices or for maintenance tasks.

Advantages

The cable offers Cat.6-level data transmission with improved protection against electromagnetic interference thanks to the foil shield. The inline switch gives simple, tool-free control over the link state, allowing users to interrupt or restore connectivity without physically removing the plug. Its 1 m length is suitable for short point-to-point links, patch panel connections, or desktop setups where space and cable management matter. Constructed for standard RJ45 ports, the cable is compatible with a wide range of network devices.

Suitable for

• Connecting computers, switches, routers and networked peripherals in office or home environments
• Temporary link control during troubleshooting, maintenance or device replacement
• Patch panel to wall outlet or short horizontal runs in structured cabling
• Situations where quick manual disconnection is required without unplugging

Key specifications

• Category: Cat.6 performance level for Ethernet networks
• Cable type: F/UTP — foil-shielded unshielded twisted pair
• Connector: RJ45 with ST < BU style termination and inline switch
• Length: 1 meter
• Supported speeds: up to Gigabit Ethernet (dependent on network equipment)
• Typical use: patch cable / short link with manual inline control

How to use

Insert each RJ45 connector into the corresponding network port until it clicks to establish a physical connection. Use the inline switch to manually toggle the link state: move the switch to the ON position to enable the connection and to the OFF position to interrupt it. Verify link and activity LEDs on connected devices to confirm network status. For reliable operation, avoid excessive bending near the connectors and keep the cable clear of strong electromagnetic sources.

Recommendations

For best performance, use the cable within recommended Cat.6 channel distances and ensure both endpoints support the intended network speed. When routing near power cables or strong EMI sources, maintain separation or use additional shielding to preserve signal integrity. Store the cable without tight coils and avoid pulling on the inline switch directly when disconnecting.