Cable de red DIGITUS CAT 6 U-UTP fino, 3 m, verde

DIGITUS CAT 6 U-UTP Slim patch cable, 3 m, green is an unshielded twisted-pair Ethernet lead designed for Gigabit networks. With Cat 6 performance up to 250 MHz and a slim overall diameter, this cable is intended for space-constrained installations such as patch panels, dense cabling racks and workstation connections. The 3-metre length is suitable for connecting switches to wall outlets or linking equipment within a rack while maintaining reliable 1 Gbit/s transmission and support for Power over Ethernet (PoE/PoE+).

Advantages

The slim cable diameter of approximately 2.7 mm and a flexible LSZH jacket reduce bulk and improve cable management in tight routing paths. Stranded AWG 32/7 bare copper conductors with HD-PE insulation provide flexibility and durability for regular handling and movement. Molded strain relief and locking lever protection on the RJ45 plugs reduce the risk of connector damage and disconnection. Compliance with international wiring and Cat 6 standards ensures predictable electrical performance and interoperability.

Suitable for

• Office and home Ethernet connections where space is limited
• Patch panels and high-density rack installations
• Switch-to-wall or switch-to-workstation cabling at short to medium distances
• PoE and PoE+ powered devices such as access points, IP phones and cameras

Key specifications

• Cable type: Unshielded twisted pair (U-UTP)
• Category: Cat 6, transmission frequency up to 250 MHz
• Length: 3 m
• Outer jacket: LSZH (Low Smoke Zero Halogen)
• Total diameter: approx. 2.7 mm ± 0.15 mm
• Conductor: Stranded AWG 32/7 bare copper
• Insulation: HD-PE (high-density polyethylene)
• Connector: RJ45 plug with molded strain relief and locking lever protection
• Bending radius: 15 × outer diameter
• Operating temperature range: -20 °C to +60 °C
• Typical supported standards: 10BASE-T, 100BASE-T, 1000BASE-T
• Service life (mating cycles): 750

How to use

Connect one RJ45 plug to the network device (switch, router or wall outlet) and the other plug to the target device (PC, access point, IP camera, etc.). Ensure the locking lever clicks into place to secure the connection and route the cable through cable management channels or ties without exceeding the specified bending radius. For rack or patch panel installations, use the slim profile to minimise congestion and maintain clear airflow. Inspect connectors for damage before use and replace the cable if the strain relief or jacket is compromised.

Recommendations

For optimal performance, keep cable runs within recommended Ethernet distance limits for the intended application and avoid running the cable parallel to high-voltage power lines. When installing in high-density environments, label both ends for easier maintenance and avoid sharp bends to preserve signal integrity.