Cable de red DSIT CAT5e, U/UTP, 50 metros, gris, 100% cobre (DC-51-500)

Running a reliable network in an office or industrial environment demands cabling that can handle constant data traffic without signal degradation. The DSIT CAT5e Network Cable delivers exactly that: a 50-meter bulk cable made from 100% solid copper conductors, ensuring excellent conductivity and minimal attenuation. With its U/UTP construction and grey PVC jacket, this cable is ideal for structured cabling installations where performance and durability are non-negotiable.

Key specifications

• Category: CAT5e
• Shielding: U/UTP (Unshielded Twisted Pair)
• Length: 50 meters
• Colour: Grey
• Conductor material: 100% copper
• Conductor type: Solid
• Wire gauge: 24 AWG
• Jacket material: PVC
• Max bandwidth: 100 MHz
• Max data transfer rate: 1 Gigabit Ethernet (1000BASE-T)
• Number of conductors: 8 (4 twisted pairs)
• Impedance: 100 Ohm
• Compliance: TIA/EIA-568-B.2
• Application: Indoor

Why choose it

Unlike cheaper copper-clad aluminium (CCA) cables, this DSIT cable uses 100% solid copper conductors, which provide superior signal integrity, lower resistance, and better support for Power over Ethernet (PoE) applications. The CAT5e rating guarantees stable performance for Gigabit Ethernet networks, making it a future-ready choice for today's high-speed demands. The sturdy PVC jacket protects the cable during installation and in everyday use, while the grey colour blends discreetly into most environments.

Ideal use cases

• Office network installations and expansions
• Connecting patch panels to wall outlets
• Running cable through conduits or cable trays
• Long-distance runs up to 50 meters without signal loss
• Supporting IP cameras, VoIP phones, and access points

Good to know

This is a bulk, unterminated cable, so you will need to crimp RJ-45 connectors or punch down to keystone jacks. It meets the TIA/EIA-568-B.2 standard, ensuring compatibility with all standard networking equipment. For best results, avoid sharp bends and maintain the minimum bend radius during installation.