Cable de red EFB Elektronik MK6001W.3B RJ-45 Cat6a 3 m negro

The EFB Elektronik MK6001W.3B is a shielded Cat.6A RJ45 patch cable, 3 m in length, designed for 10 Gigabit Ethernet networks. It provides data transfer rates up to 10000 Mbit/s and uses S/FTP shielding to reduce electromagnetic interference. One connector is moulded at a 90° angle and the slim moulded grommet simplifies insertion in confined spaces.

Advantages

The S/FTP shielding ensures low crosstalk and improved signal integrity for high-speed connections. Cat6a specification supports stable 10GBase-T performance. The angled RJ-45 connector and slim moulded grommet facilitate cable routing and connector insertion in tight racks or behind equipment. Standard 3 m length offers flexibility for typical patching scenarios.

Suitable for

• 10 Gigabit Ethernet (10GBase-T) networks
• Server racks and network cabinets with limited rear space
• Workstations and switches requiring Cat6a connections
• Office and data centre patch panels

Key specifications

• Length: 3 m
• Connectors: RJ-45 — both ends (one 90° angled)
• Performance: Cat6a, up to 10000 Mbit/s
• Shielding: S/FTP (shielded foil with braided shield for pairs)
• Colour: Black
• Cabling technology: 10GBase-T

How to use

Connect the straight RJ-45 end and the 90° angled RJ-45 end to the corresponding ports on your switch, patch panel or device. Route the cable using the slim moulded grommet to pass through narrow gaps or behind equipment. Ensure connectors are fully inserted until the latch clicks to secure the connection. Avoid sharp bends near the connector to maintain signal integrity.

Recommendations

For optimal 10G performance, use within specified 3 m length and avoid running the cable parallel to high-voltage power lines. Maintain bend radius and avoid excessive tension on the cable and connectors.