Cable de red Ethernet ShiverPeaks 75512-S CAT 7 S/FTP 2 m LSZH libre de halógenos

ShiverPeaks 75512-S is a CAT 7 Ethernet patch cable with S/FTP (shielded foil around each pair plus overall braid) construction, a 2.0 m length and a low-smoke, halogen-free (LSZH) jacket. The cable is intended for high-speed network connections in offices, data centers and home LANs, offering enhanced protection against electromagnetic interference and reduced toxic emissions in case of fire. It supports Gigabit and 10 Gigabit Ethernet over short runs and comes in black.

Advantages

The S/FTP shielding and PIMF pair design provide reliable protection from crosstalk and external interference, improving signal integrity for high-speed data transmission. The LSZH jacket reduces smoke and halogen emissions in fire scenarios. At 2 m length the patch cable is convenient for rack, desk and equipment connections where short links are required. Standard RJ45 terminations ensure compatibility with common network devices.

Suitable for

• Office and corporate LAN connections
• Patch panels and rack-mounted equipment in data centers
• Home networks and multimedia setups
• Short runs for Gigabit and 10 Gigabit Ethernet links

Key specifications

• Model: ShiverPeaks 75512-S
• Category: CAT 7
• Shielding: S/FTP (foil per pair + overall braid), PIMF
• Length: 2.0 m
• Jacket: LSZH (halogen-free), color: black
• Connector: RJ45
• MPN: 75512-S
• EAN: 4017538675385

How to use

Connect one RJ45 plug to your network device (switch, router, network card) and the other RJ45 plug to the corresponding port on the second device or patch panel. Avoid sharp bends and excessive pulling on the cable; maintain the minimum bend radius recommended for Ethernet cables. For best performance, use the cable for connections up to the specified short-run distances typical for CAT 7 in patching and equipment interconnects.

Recommendations

Use this CAT 7 S/FTP patch cable for short interconnects where improved shielding is required. Install in spaces where LSZH materials are preferred for reduced smoke and halogen emissions. Do not exceed recommended bend radius or apply strain that could damage the RJ45 connectors or cable shield.