Cable de red InLine Cat6 S-76412U 250 MHz, 1,2 m, RJ45

InLine Cat6 patch cable S-76412U is a 1.2 m RJ45 network cable designed to support network connections with up to 250 MHz bandwidth. Suitable for Gigabit Ethernet environments, this cable offers a compact connection solution for linking computers, switches, routers and patch panels in home and office networks. Its standard RJ45 connectors and 1.2 metre length make it practical for short runs behind desks, in server racks and between nearby network devices.

Advantages

The Cat6 construction improves signal integrity and reduces crosstalk compared with lower-category cables, providing stable data transmission at higher frequencies. With a 250 MHz rating and standard RJ45 terminations, the cable supports Gigabit Ethernet speeds and is compatible with common network equipment. The 1.2 m length balances reach and cable management, helping to keep installations tidy and minimizing excess slack.

Suitable for

• Connecting desktop PCs or laptops to network switches or routers
• Patch panel to switch connections within racks
• Short interconnects between networked devices in home and small office setups
• Temporary connections for testing and troubleshooting network links

Key specifications

• Cable category: Cat6
• Bandwidth: up to 250 MHz
• Length: 1.2 m
• Connector type: RJ45 on both ends
• Intended data rate: suitable for Gigabit Ethernet

How to use

Plug one RJ45 connector into the network port of your computer, switch, router or patch panel and the other connector into the corresponding port of the remote device. Ensure connectors are fully inserted until the latch engages. Route the cable to avoid sharp bends and sources of electrical interference; if used in a rack, secure excess length with cable ties or Velcro straps to maintain airflow and organization. For optimal performance, avoid running the cable in parallel with power lines over long distances.

Recommendations

Use this Cat6 patch cable for short to medium-length indoor connections where Gigabit Ethernet performance is required. Verify device port speeds and duplex settings when integrating into existing networks, and replace any cable with visible damage or compromised connectors to maintain link reliability.