Cable de red LANBERG Cat6a S/FTP recto RJ-45 10 m, conductor CCA, funda LSZH, 500 MHz, negro

LANBERG PCF6A-10CC-1000-BK Cat6a S/FTP straight-through RJ-45 10 m is a shielded Ethernet cable designed for high-speed wired networks. The 10 m black jacketed cable features RJ-45 connectors on both ends and S/FTP shielding that combines an overall foil with individually shielded pairs to limit electromagnetic interference and maintain signal integrity over longer runs. It is intended for connecting devices such as switches, routers, patch panels and network ports in home and office environments where Cat6a performance is required.

Advantages

The S/FTP construction provides improved protection against near-end crosstalk and external electromagnetic noise compared with unshielded cables. Cat6a category compliance supports 10 Gigabit Ethernet over typical horizontal cabling distances while the straight-through wiring and standard RJ-45 terminations ensure broad compatibility with network equipment. The 10 m length offers flexibility for mid-range links without excess slack, and the black outer jacket gives a discreet, professional appearance suitable for visible installations.

Suitable for

Key specifications

How to use

Connect one RJ-45 end to the network device (switch, router, patch panel or wall socket) and the other end to the target device (PC, server or network appliance). Ensure connectors are fully inserted until the latch clicks and avoid sharp bends or kinks near the connector boot. Route the cable away from high-voltage power lines and sources of strong electromagnetic interference to preserve signal quality. If used in shielded installations, connect cable shields to properly grounded components according to the site grounding scheme.

Recommendations

For reliable 10 Gigabit performance, maintain recommended installation practices: avoid tight bends (minimum bend radius as per installation standards), limit cable ties or compressive force near connectors, and use properly grounded shielded patch panels or outlets where applicable. Verify link speed and duplex settings on connected devices after installation.