Cable de red Lanberg PCF6-10CU-0025-BK RJ-45 Cat6 0,25 m negro

The Lanberg PCF6-10CU-0025-BK RJ-45 Cat6 0.25 m Black is a short patch cable designed for reliable Ethernet connections in constrained spaces. Built to Cat6 specification with F/UTP shielding, this cable supports high-speed data transmission while minimizing electromagnetic interference. Its compact 0.25 m length and standard RJ-45 connectors make it suitable for patch panels, switches, routers and directly linked devices where space is limited.

Advantages

The F/UTP shielding provides improved protection against external electromagnetic interference compared with unshielded cables, helping to maintain signal integrity in environments with nearby electrical equipment. Cat6 performance ensures support for gigabit Ethernet and stable throughput for common network tasks. The short length reduces cable clutter and latency for adjacent connections, and the black jacket offers a discreet, professional appearance that blends with most installations.

Suitable for

• Patching between switches and patch panels in server racks
• Connecting network equipment in compact workstations
• Direct device-to-device links where only short runs are required
• Structured cabling environments requiring shielded cabling

Key specifications

• Cable category: Cat6
• Shielding: F/UTP (foil shielded pairs with overall unshielded jacket)
• Connector type: RJ-45 to RJ-45
• Length: 0.25 m
• Color: Black

How to use

Insert the RJ-45 connector into the corresponding Ethernet port until the latch clicks to secure the connection. Use the cable to link network equipment such as switches, routers, patch panels or PCs. For best performance, avoid sharp bends and excessive tension; maintain gentle curves and ensure connectors are fully seated. Keep the cable away from high-voltage sources and large power transformers to reduce potential interference.

Recommendations

For reliable operation, use this short Cat6 cable for intra-rack or desk-level connections where run length is minimal. Pair with shielded network equipment or properly grounded racks when using F/UTP cabling to ensure optimal noise suppression. Replace the cable if connectors show wear or if performance issues are observed.