Cable de red Lanberg PCF6A-10CU-0100-BK negro 1m Cat6a S/FTP

The Lanberg PCF6A-10CU-0100-BK Black 1m Cat6a S/FTP is a 1 metre network patch cable engineered for reliable high-speed Ethernet connections. Built to Cat6a (Class Ea) standards with S/FTP shielding (braid plus foil on each pair) and 100% copper conductors, this cable supports frequencies up to 500 MHz and data rates up to 10 Gb/s. The cable uses RJ-45 connectors on both ends and is sheathed in a black LSZH jacket for reduced smoke and no halogen in case of fire, making it suitable for professional and commercial installations.

Advantages

The S/FTP shielding minimises external electromagnetic interference and pair-to-pair crosstalk, improving signal integrity for demanding applications. The 27 AWG copper conductors (7 x 0.135 mm) provide consistent conductivity while the 6.0 mm ±0.2 mm outer diameter balances flexibility and mechanical robustness. Compliance with ISO/IEC 11801 class Ea and ANSI/TIA/EIA-568-B compatibility ensures predictable performance within structured cabling systems.

Suitable for

Key specifications

How to use

Connect one RJ-45 end of the cable to the network port of your device (switch, router, network card or patch panel) and the other end to the corresponding port on the remote device. Ensure that connectors are fully seated and latched to maintain reliable contact. Route the cable avoiding tight bends, sharp edges and sources of strong electromagnetic interference to preserve shielding effectiveness and signal performance.

Recommendations

For best results, use the cable for short structured cabling runs inside racks, between adjacent equipment or patch panels. Maintain minimum bend radius as implied by the cable outer diameter, avoid over-tightening cable ties, and keep the cable separated from unshielded power conductors to reduce potential interference.