Cable de red Lanberg PCF7-10CU-1000-S RJ-45 Cat7 10 m gris

The Lanberg PCF7-10CU-1000-S RJ-45 Cat7 10 m Grey is a straight-through networking cable designed for wired Ethernet connections requiring high shielding and stable throughput. Built to the Cat7 standard with S/FTP shielding and fitted with RJ-45 connectors on both ends, this 10-meter cable supports data transfer rates up to 1250 Mbit/s and is intended for use in home, office, or data-centre patching where electromagnetic interference suppression and consistent signal integrity are important.

Advantages

The cable's S/FTP shielding configuration provides improved protection against external electromagnetic interference compared with unshielded alternatives, helping to maintain signal quality over the full 10 m length. RJ-45 terminations at both ends ensure broad compatibility with switches, routers, network interface cards and other Ethernet-enabled equipment. A grey outer jacket gives a neutral appearance suitable for visible installations while the construction is intended for reliable, long-lasting use in typical networking environments.

Suitable for

• Connecting desktop PCs, laptops and networked printers to switches or routers
• Patch panel to switch connections in small server rooms or wiring closets
• Workstation cabling in offices where shielding is preferred to reduce interference
• Temporary or permanent Ethernet runs where a 10 m length is required

Key specifications

• Cable type: Straight-through cable
• Category: Cat7
• Shielding: S/FTP (shielded foiled twisted pair)
• Data transfer rate: up to 1250 Mbit/s
• Connector type: RJ-45 on both ends
• Cable length: 10 m
• Color: Grey

How to use

Identify the network ports on your devices and insert each RJ-45 connector firmly into the corresponding Ethernet port until the locking tab clicks. Route the 10 m cable to avoid sharp bends and to minimize contact with power cables or sources of electromagnetic noise. For permanent installations, use appropriate cable management such as clips or cable ties to secure the run and reduce mechanical strain on the connectors. If replacing an existing cable, ensure both ends are connected to matching ports and test the link status on connected devices to confirm network connectivity and speed.

Recommendations

For optimal performance, avoid running the Lanberg Cat7 cable in parallel with mains power cables for extended distances and maintain gentle bend radii consistent with typical Ethernet cable handling. Use the cable for shielded or higher-noise environments where S/FTP protection will provide benefit, and verify connector seating if link issues occur.