Cable de red LANBERG PCU6-10CC-0200-B Cat6 U/UTP RJ-45 a RJ-45 2 m azul, conductor CCA, 250 MHz

The Lanberg PCU6-10CC-0200-B RJ-45 Cat6 2 m Blue is a Cat6 U/UTP patch cable with RJ-45 connectors on both ends and a 2 meter length. It is intended for use in Ethernet networks where a short, flexible connection is required between network devices such as switches, routers, patch panels and computers. The blue jacket provides easy visual identification within structured cabling runs and small installations.

Advantages

This Cat6 cable supports reliable data transmission at typical Ethernet speeds for Cat6 cabling and is suitable for standard structured network deployments. The U/UTP construction offers a compact, untwisted pair shielding approach that keeps the cable flexible while maintaining signal integrity for short to medium runs. The RJ-45 connectors on both ends ensure straightforward plug-and-play installation without the need for additional adapters.

Suitable for

Key specifications

How to use

Plug one RJ-45 connector into the network port of the source device (for example a router or switch) and the other connector into the network port of the destination device (for example a PC, console or access point). Ensure connectors are fully seated until the latch clicks. Route the cable avoiding tight bends and sharp edges to preserve performance; leave some slack where movement may occur. For rack or patch panel installations, label both ends if needed to simplify future troubleshooting.

Recommendations

Use this Cat6 patch cable for short to medium connections in home and small office environments. Avoid running the cable parallel to high-voltage power lines for long distances to reduce potential interference. For environments requiring enhanced noise immunity or longer runs, consider shielded or higher-category alternatives.