Cable de red Lindy 47199 blanco 15 m Cat6a S/FTP (S-STP)

The Lindy 47199 15m Cat6 S/FTP networking cable is designed for reliable wired Ethernet connections in home and office environments. The cable uses Category 6 specifications with S/FTP shielding and terminated RJ-45 connectors with gold-plated contacts to maintain signal integrity and reduce interference over a 15 metre run. It supports 10/100/1000Base-T(X) data rates up to 1000 Mbit/s and is finished in white for a discreet installation.

Advantages

S/FTP shielding (overall foil plus individually shielded pairs) provides improved protection against electromagnetic interference and crosstalk compared with unshielded cables, helping to sustain stable gigabit speeds over the full 15 m length. Gold-plated RJ-45 contacts ensure low contact resistance and corrosion resistance for consistent performance. The Category 6 specification offers better headroom for bandwidth and reduced attenuation versus lower categories, and the white jacket supports tidy, unobtrusive routing in visible areas.

Suitable for

• Gigabit Ethernet connections between switches, routers and desktop or networked devices
• Structured cabling segments in small offices and home networks
• Connecting networked printers, IP cameras and network-attached storage
• Temporary or permanent runs where a 15 m length is required

Key specifications

• Cable category: Cat6
• Shielding: S/FTP (overall foil with individually shielded pairs)
• Length: 15 m
• Connectors: RJ-45 to RJ-45
• Contacts: Gold-plated
• Supported data rates: 10/100/1000Base-T(X), up to 1000 Mbit/s
• Outer jacket colour: White

How to use

Route the 15 m Cat6 cable between the two network devices, taking care to avoid running parallel to high-voltage power cables for extended distances to minimise potential interference. Insert each RJ-45 plug fully into the device ports until a click is felt to ensure a secure connection. For best performance, keep cable bends gentle and avoid tight kinks; maintain recommended bend radius for Cat6 cables. Where possible, use proper cable management (clips, trunking or cable ties) to prevent stress on the connectors and to maintain signal integrity.

Recommendations

Use this S/FTP Cat6 cable for installations that require stable gigabit performance and improved immunity to interference. For runs longer than 15 m, consider structured cabling with intermediate patch panels or higher-category cabling where needed. If the installation environment has high electromagnetic noise, ensure proper grounding of connected equipment and follow local cabling standards.