Cable de red LogiLink 1m Cat.6A RJ-45 S/FTP Amarillo

LogiLink 1m Cat.6A RJ-45 S/FTP Yellow is a 1.00 m patch cable designed for high-speed network connections up to 10 Gbps. The cable uses S/FTP (shielded with foil around each pair and overall braid) construction with PIMF (pairs in metal foil) and AWG 26/7 conductors of bare copper. It has RJ45 connectors on both ends and an LSZH (low smoke zero halogen) jacket for reduced smoke and toxic gas emission in case of fire.

Advantages

The shielded S/FTP PIMF design minimizes electromagnetic interference and crosstalk, supporting stable high-bandwidth transmission. Cat.6A specification and compliance with ISO/IEC 11801, EN50288 and TIA/EIA 568-C.2 standards ensure compatibility with structured cabling systems. The 1 m length and bright yellow jacket make the cable easy to route and identify in patch panels and rack installations.

Suitable for

• Connecting switches, routers and network interfaces in data centres and offices
• Patching between patch panels and active equipment in racks
• High-speed LAN connections requiring up to 10 Gbps bandwidth
• Environments where low-smoke, zero-halogen cable jacket is required

Key specifications

• Category: Cat.6A (10G)
• Length: 1.00 m
• Cable type: S/FTP (PIMF)
• Conductor: AWG 26/7 bare copper
• Connectors: RJ-45 — both ends
• Jacket: LSZH (low smoke zero halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Colour: Yellow
• Weight: 40 g

How to use

Plug RJ45 connectors into the appropriate Ethernet ports on devices such as switches, routers, network interface cards or patch panels. Ensure connectors are fully inserted and locked. Route the cable to avoid sharp bends and sources of strong electromagnetic interference. For permanent installations, secure the cable with appropriate cable management accessories without compressing the jacket.

Recommendations

For optimal performance, use this Cat.6A S/FTP cable for short runs up to 1 m between equipment in racks or workstations. Avoid excessive bending radius and keep the cable separate from power lines to reduce potential interference.