Cable de red LogiLink 1m RJ-45 Cat6a azul

The LogiLink 1m RJ-45 Cat6a Blue networking cable is a shielded S/FTP Patch Cable designed for high-speed wired Ethernet connections. With support for data rates up to 10000 Mbit/s and a 1 m length, this cable is intended for short, reliable connections between network devices. The construction uses bare copper conductors and a low smoke zero halogen (LSZH) jacket, and the cable meets ISO/IEC 11801, EN50288 and TIA/EIA 568-C.2 standards.

Advantages

The S/FTP shielding (overall foil with individually shielded pairs) reduces electromagnetic interference and crosstalk, improving signal integrity for high-bandwidth applications. Cat6a specification and AWG 26/7 conductor configuration provide stable performance at higher frequencies, while RJ-45 connectors on both ends ensure broad compatibility. The LSZH jacket minimizes toxic fumes in case of fire and the bare copper conductors offer reliable conductivity.

Suitable for

• Short wired connections between switches, routers and patch panels
• High-speed Ethernet links up to 10 Gbit/s in home or office setups
• Areas requiring reduced electromagnetic interference (shielded runs)
• Environments where low-smoke, zero-halogen cable jackets are preferred

Key specifications

• Length: 1 m
• Cable type: Cat6a S/FTP (PIMF)
• Conductor: Bare copper, AWG 26/7
• Connector: RJ-45 — both ends
• Max data rate: up to 10000 Mbit/s (10 Gbit/s)
• Jacket: LSZH (Low Smoke Zero Halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Colour: Blue
• Weight: 40 g

How to use

Connect one RJ-45 plug to a network device (switch, router, computer or patch panel) and the other RJ-45 plug to the target device. Ensure both devices are powered and configured for the intended Ethernet speed. Avoid tight bends and excessive tension; maintain recommended bend radius for cabling to preserve performance. For installations requiring shielding continuity, connect cable shields to grounded equipment or patch panels where appropriate.

Recommendations

For optimal performance at 10 Gbit/s, keep the cable length within specification limits for Cat6a and avoid running parallel to strong sources of electromagnetic interference. Use shielded connectors and grounded patch panels in installations that rely on S/FTP shielding.