Cable de red LogiLink Cat6a S/FTP RJ-45 1,5 m rojo

The LogiLink Cat6a S/FTP RJ-45 networking cable, 1.5 m in length and red in color, is built for high-speed Ethernet connections. It uses S/FTP (shielded with foil around each pair and an overall braid) construction with bare copper conductors and AWG 26/7 stranded wires, and is compatible with standards such as ISO/IEC 11801 and TIA/EIA 568-C.2. The LSZH (low smoke zero halogen) jacket reduces harmful emissions in case of fire and the RJ45 connectors provide a standard interface for network devices.

Advantages

The S/FTP shielding minimizes electromagnetic interference and crosstalk, improving signal integrity for Cat6a performance. AWG 26/7 stranded bare copper conductors offer flexibility and reliable contact. The LSZH outer jacket enhances safety in enclosed spaces by emitting less smoke and no halogenated gases. The 1.5 m length is suitable for short runs between devices while the red color helps with visible cable identification.

Suitable for

• Connecting computers, switches and routers in home or office networks
• Short to medium patch runs in server rooms and network cabinets
• High-speed 10 Gigabit Ethernet links over short distances

Key specifications

• Length: 1.5 m
• Cable type: Cat6a S/FTP (PIMF)
• Conductor: bare copper, AWG 26/7
• Connectors: RJ-45 to RJ-45
• Jacket: LSZH (low smoke zero halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Weight: 60 g
• Color: Red

How to use

Plug each RJ45 connector into the corresponding network ports on your devices (for example, computer to switch or switch to router). Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid running it parallel and close to high-voltage power cables to reduce interference. For permanent installations, use appropriate cable management and strain relief.

Recommendations

For optimal performance, use this Cat6a S/FTP cable for short runs up to 1.5 m and within structured cabling that meets Cat6a installation practices. Avoid excessive bending and tensile stress; maintain separation from mains power lines where possible. The LSZH jacket makes it suitable for indoor use in areas where low smoke emission is required.