Cable de red LogiLink Cat6a S/FTP RJ-45 7,5 m gris

The LogiLink Cat6a S/FTP RJ-45 networking cable, 7.5 m in length, is built for high-speed data transmission and stable wired connections. It uses S/FTP (shielded foil around each pair plus overall braid) construction with bare copper conductors and RJ-45 connectors, and is covered by an LSZH (low smoke zero halogen) jacket. The cable conforms to ISO/IEC 11801, EN50288 and TIA/EIA 568-C.2 standards and weighs approximately 270 g.

Advantages

S/FTP shielding and PIMF pair isolation reduce electromagnetic interference for improved signal integrity. AWG 26/7 stranded bare copper conductors provide reliable conductivity while allowing flexibility along the 7.5 m length. The LSZH jacket limits smoke and hazardous gases in the event of fire, making the cable suitable for indoor installations. Compliance with international cabling standards ensures compatibility with structured network systems.

Suitable for

• Wired Ethernet connections for desktops, switches and routers
• High-speed data and multimedia transmission (Cat6a performance)
• Office and home network installations where reduced smoke emissions are required

Key specifications

• Cable type: Cat6a S/FTP (PIMF)
• Length: 7.5 m
• Connectors: RJ-45 to RJ-45
• Conductor: AWG 26/7 bare copper
• Jacket: LSZH (low smoke zero halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Weight: 270 g
• Colour: Grey

How to use

Connect each RJ-45 plug to the corresponding Ethernet ports on your devices (for example, a computer and a switch or router). Ensure connectors are fully inserted until they click to establish a secure connection. Route the cable without tight bends and avoid kinking; maintain reasonable separation from high-voltage power sources and strong electromagnetic equipment to preserve signal quality.

Recommendations

For optimal performance, use this Cat6a S/FTP cable for Gigabit and 10 Gigabit Ethernet within its intended run length, avoid excessive twisting or compression, and install in indoor environments where LSZH properties are required. Test connections with network diagnostic tools after installation to confirm link speed and stability.