Cable de red LogiLink CQ2142S RJ-45 Cat6 50 m gris

The LogiLink CQ2142S RJ-45 Cat6 50 m Grey networking cable is a Category 6 patch cable designed for structured network installations in homes and offices. It provides a 50-meter length with RJ-45 connectors on both ends and employs SF/UTP shielding to limit electromagnetic interference and maintain signal integrity over longer runs. Contacts are copper plated to support consistent electrical contact and data transfer rates typical for Cat6 performance.

Advantages

This Cat6 cable combines SF/UTP shielding with a 50 m length to enable reliable connections across rooms or between network equipment racks without excessive signal degradation. The use of RJ-45 terminations on both ends ensures wide compatibility with switches, routers, patch panels and network interfaces. The grey jacket provides a neutral appearance suitable for visible routing in office and residential environments.

Suitable for

• Wired Ethernet connections between switches, routers and patch panels
• Home network installations and office desktop connections
• Structured cabling runs where interference reduction is required
• Temporary or permanent connections in server rooms or network cabinets

Key specifications

• Category: Cat6
• Length: 50 m
• Shielding: SF/UTP (braided shield with foil for individual pairs/overall)
• Connectors: RJ-45 on both ends
• Contact plating: copper-plated contacts
• Colour: Grey

How to use

Route the cable from your network device to the target port, avoiding sharp bends and sources of strong electromagnetic interference such as high-voltage power lines or large motors. Insert the RJ-45 plug into the corresponding jack until it clicks. For installations in patch panels or keystone jacks, verify proper termination and labeling at both ends. Test the link with a network tester after installation to confirm continuity and performance.

Recommendations

For optimal performance maintain bend radius greater than four times the cable diameter, avoid running the cable parallel to power lines for extended distances, and use appropriate cable management and strain relief when passing through conduits or attaching to racks.