Cable de red LogiLink CQ6095S RJ-45 Cat6a 10 m negro

The LogiLink CQ6095S RJ-45 Cat6a 10 m Black is a network patch cable designed for reliable high-speed data transmission in wired Ethernet environments. Supporting transfer rates up to 10000 Mbit/s, this 10 meter Cat6a cable uses S/FTP shielding and standard RJ-45 connectors on both ends to maintain signal integrity and broad device compatibility. Its black outer jacket provides a discreet appearance suitable for home, office or server rack installations.

Advantages

S/FTP shielding reduces crosstalk and external electromagnetic interference, helping to preserve consistent throughput at higher network speeds. The Cat6a specification allows for improved performance over Cat5e and Cat6 at 10 Gigabit Ethernet distances where cable quality and shielding matter. Standard RJ-45 terminations ensure plug-and-play connection with switches, routers, NAS devices and network interface cards that accept 8P8C modular plugs.

Suitable for

• 10 Gigabit Ethernet connections between switches and servers
• Wired home networking and multimedia streaming
• Office workstations, VoIP phones and printers
• Structured cabling runs in small server rooms and racks

Key specifications

• Cable category: Cat6a
• Data transfer rate: up to 10000 Mbit/s
• Shielding: S/FTP (overall braid with individually shielded pairs)
• Connectors: RJ-45 on both ends (8P8C)
• Length: 10 m
• Outer colour: Black

How to use

Connect one RJ-45 end to the network port of your switch, router, server or device and the other end to the corresponding port on the remote device. For best signal quality, avoid tight bends or kinks in the cable and keep it separated from sources of strong electromagnetic interference such as unshielded power cables or large motors. For permanent installations, secure the cable with appropriate clips or cable management components to prevent strain on the connector ends.

Recommendations

Use the cable for horizontal and patch panel connections within its 10 m length specification. When deploying at high data rates, ensure connected network equipment and ports support 10 Gigabit operation and that connectors are fully seated. Replace the cable if the jacket or connectors show visible damage to maintain reliable network performance.