Cable de red LOGON Cat6 SSTP/PIMF 15 m, RJ-45–RJ-45, verde

LOGON Cat6 SSTP/PIMF 15 m networking cable with RJ-45 connectors at both ends provides a 15-metre connection for wired LAN setups. Constructed to Cat6 standard and rated for 250 MHz, this SSTP (shielded, screen twisted pair) / PIMF (pairs in metal foil) cable reduces electromagnetic interference and crosstalk, ensuring stable throughput for gigabit Ethernet and other high-speed network applications. The cable is finished in a green jacket and fitted with shielded RJ-45 plugs at each end with boots that include kink protection and strain relief.

Advantages

The SSTP/PIMF shielding design combines foil around each pair with an overall braid to minimise external noise and improve signal integrity over the 15 m run. AWG 26/7 conductor construction and 100 Ohm impedance are matched to Cat6 requirements for reliable transmission up to the specified frequency. The shielded RJ-45 connectors help maintain continuity of the shield through the plug, and the integrated strain relief reduces mechanical stress at termination points to extend service life.

Suitable for

• Office and home LAN connections requiring reliable gigabit Ethernet links
• Patching between switches, routers, patch panels and wall outlets
• Environments with potential electromagnetic interference where shielded cabling is preferred
• Structured cabling installations needing a 15 m Cat6 channel-compatible link

Key specifications

• Cable category: Cat6
• Shielding: SSTP / PIMF (foil on pairs + overall braid)
• Frequency rating: 250 MHz
• Conductor: 4 pairs, AWG 26/7, twisted pairs
• Characteristic impedance: 100 Ohm
• Length: 15 m
• Connectors: shielded RJ-45 male – RJ-45 male
• Boot: kink protection and strain relief
• Certification: 3P Cat.6 Channel Link certified
• Wiring: 1:1 (straight-through)

How to use

Connect one shielded RJ-45 plug to the network device (switch, router, patch panel) and the other plug to the destination port, ensuring both ends seat securely. For shielded installations, bond the cable shield to the network equipment chassis or a proper grounding point as required by the installation practice to preserve shielding effectiveness. Avoid sharp bends or kinks and route the cable away from sources of strong electromagnetic noise when possible.

Recommendations

For best performance, use this Cat6 SSTP/PIMF cable within the specified 15 m length as part of a properly terminated Cat6 channel. Ensure connectors and equipment support shielded connections and grounding; inspect boots and strain reliefs after installation to verify there is no undue mechanical stress.