Cable de red LOGON Cat6 SSTP/PIMF 7 m, RJ-45 a RJ-45, azul

LOGON Cat6 SSTP/PIMF networking cable, 7 m length, with RJ-45 connectors at both ends. Designed to Cat6 standard for Gigabit Ethernet networks, this cable supports up to 250 MHz and uses 4 x 2 AWG 26/7 twisted pairs with 100 Ohm impedance. The combined foil and braid (PIMF/SSTP) shielding and shielded RJ-45 connectors reduce electromagnetic interference and crosstalk, providing a stable wired connection for switches, routers, PCs and other networked devices. A blue outer jacket makes the cable easy to identify in patch panels and cable runs.

Advantages

The LOGON Cat6 SSTP/PIMF cable offers improved noise rejection compared with unshielded alternatives, thanks to foil plus braid shielding and shielded connectors. Its 7 m length provides flexibility for typical home and office setups, while the 250 MHz rating and Cat6 construction support reliable Gigabit Ethernet performance. Integrated boot with kink protection and strain relief helps preserve connector integrity during installation and handling.

Suitable for

• Connecting switches and routers in wired LANs
• Linking desktop PCs and workstations to network ports
• Patch panel to switch or patch panel to wall outlet cabling
• Small office or home office (SOHO) structured cabling

Key specifications

• Length: 7 m
• Category: Cat6
• Shielding: SSTP / PIMF (foil plus braid)
• Conductor: 4 x 2 AWG 26/7 twisted pairs
• Impedance: 100 Ohm
• Frequency: up to 250 MHz
• Connectors: 2 × RJ-45 shielded (male to male)
• Channel/Link certification: 3P Cat.6 Channel Link certified
• Jacket color: blue
• Connection wiring: 1:1 (straight-through)

How to use

Connect one RJ-45 end to the Ethernet port of a switch, router or wall outlet and the other RJ-45 end to the device requiring network access. Ensure shielded connector shells are properly mated to shielded ports where available to maintain the effectiveness of the SSTP/PIMF shielding. Route the cable without sharp bends and avoid running parallel to high-voltage power lines where possible to minimise potential interference.

Recommendations

For optimal performance, use the cable within its 7 m length and avoid excessive bending or repeated flexing near the connector boots. When deploying in environments with significant electromagnetic noise, pair the shielded cable with grounded shielded ports or patch panels to maximize interference protection.