Cable de red LOGON Cat6 UTP 7 m rojo, RJ-45 a RJ-45, Cat6 UTP

LOGON Cat6 UTP networking cable, 7 m length, terminated with RJ-45 connectors on both ends. This Cat6 UTP patch cable is built for Gigabit Ethernet and designed for use in home and office networks where reliable copper cabling and clear visual identification are required. The cable uses four twisted pairs with 26 AWG stranded conductors and a 100 ohm characteristic impedance, and its red PVC jacket makes it easy to spot in cable runs.

Advantages

The cable provides Cat6 performance up to 250 MHz for stable data transfer and reduced crosstalk compared with lower-category cables. RJ-45 male connectors on both ends with boots featuring kink protection and strain relief help prolong connector life and maintain consistent connections. A visible spot length marking on the boot assists with installation planning and cable management.

Suitable for

• Connecting desktop computers, laptops and network printers to switches or routers
• Patch panel to switch or switch to switch connections in small office setups
• Structured cabling runs where color-coding (red) aids identification and troubleshooting

Key specifications

• Cable category: Cat6 UTP (unshielded twisted pair)
• Length: 7 m
• Conductor: 4 x 2 AWG 26/7 stranded
• Characteristic impedance: 100 Ω
• Bandwidth: up to 250 MHz
• Connectors: RJ-45 male to RJ-45 male
• Connector features: boots with kink protection and strain relief, spot length marking
• Certification: Category 6 performance (3 P certified)
• Color: red PVC jacket

How to use

Plug each RJ-45 connector into the corresponding network ports on devices such as computers, switches, routers or patch panels until the connector latches. Route the cable avoiding sharp bends and sources of electromagnetic interference. Use the spot length marking to measure and confirm routing length during installation. Ensure both ends are fully seated and test the link using network diagnostic tools or a cable tester to confirm continuity and correct pairing.

Recommendations

For optimal performance, avoid routing the cable parallel and close to high-voltage power lines and fluorescent lighting. Use appropriate cable management (cable ties, trays) to prevent excessive bending near connector boots. For permanent installations, verify link performance with a certified tester to ensure Cat6 parameters are met over the entire run.