Cable de red LOGON SSTP Cat6a RJ-45 RJ-45 0,5 m verde

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable is 0.5 m long and designed for reliable high-speed data transmission. It features SSTP shielding with paired foil and full braid protection, four twisted pairs (4 x 2 x AWG 26/7) with 100 Ohm impedance, and shielded RJ45 male connectors on both ends. The cable has a boot with kink protection and strain relief and uses a straight-through 1:1 EIA/TIA 568B wiring scheme.

Advantages

This Cat6a SSTP cable provides increased resistance to electromagnetic interference thanks to combined foil and braid shielding. The 100 Ohm twisted pairs (AWG 26/7) support high-speed network connections, while shielded RJ45 connectors and a reinforced boot with strain relief improve connection stability and durability. The compact 0.5 m length makes it suitable for short connections in patch panels, switches, or close-proximity devices.

Suitable for

• Short patch connections between network devices (switches, routers, patch panels)
• High-speed Ethernet links requiring Cat6a performance
• Environments with potential electromagnetic interference where SSTP shielding is beneficial
• Desk- or rack-mounted connections where a 0.5 m cable is appropriate

Key specifications

• Cable type: SSTP Cat6a
• Length: 0.5 m
• Connectors: RJ-45 (male) — both ends, shielded
• Conductor/structure: 4 x 2 x AWG 26/7, twisted pair
• Impedance: 100 Ohm
• Wiring: 1:1 — EIA/TIA 568B (straight-through)
• Colour: Green

How to use

Connect one shielded RJ45 plug to the network port of your device and the other to the corresponding port on the switch, router or patch panel. Ensure connectors are fully inserted until the latch clicks. Use the cable for short links up to 0.5 m where Cat6a performance and SSTP shielding are required. Avoid sharp bends near the boot to maintain kink protection and strain relief.

Recommendations

For optimal performance, route the cable away from high-power electrical lines and large sources of interference. Verify the port supports the required Ethernet speed and test the link after installation to confirm correct wiring and signal integrity.