Cable de red LOGON SSTP Cat6a RJ-45 RJ-45 3 m naranja

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 3 m in length and orange in color, is designed for high-speed wired data transmission. It conforms to Cat6a requirements and supports up to 10 Gbps over suitable network equipment. The cable uses SSTP construction with foil and full braid shielding and comes terminated with two shielded RJ45 male connectors and boots with kink protection and strain relief. Wiring follows a 1:1 EIA/TIA 568B pinout.

Advantages

SSTP shielding (foil plus full braid) reduces electromagnetic interference and provides improved signal integrity for demanding environments. Twisted pair construction (4 x 2 x AWG 26/7) with a characteristic impedance of 100 Ohm supports stable high-speed transmission. Shielded RJ45 connectors and strain-relief boots increase durability and reduce connector stress during frequent handling or installation. The 3 m length offers flexibility for rack, workstation, or home networking runs while the orange jacket improves visibility in cable bundles.

Suitable for

• Connections between switches, routers, and patch panels in data centers and comms cabinets
• High-speed desktop or workstation networking requiring Cat6a performance
• Home networks and office setups where visible cable identification is needed

Key specifications

• Cable type: SSTP Cat6a, 4 x 2 x AWG 26/7 twisted pairs
• Impedance: 100 Ohm
• Connectors: RJ-45 male shielded — 2x
• Pinout: 1:1 EIA/TIA 568B
• Length: 3 m
• Colour: Orange

How to use

Plug each shielded RJ45 connector into the corresponding RJ45 port on network devices such as switches, routers, patch panels, or network interface cards. Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends; the boot provides kink protection but maintaining gentle bend radii preserves performance. For best results, avoid running the cable parallel to high-power electrical lines to minimize interference.

Recommendations

Use the LOGON SSTP Cat6a cable for links intended to carry Gigabit and 10 Gigabit Ethernet where shielded cabling is beneficial; verify both connected devices and network infrastructure support Cat6a/10G operation over the chosen link length.