Cable de red LOGON SSTP Cat6a RJ-45 RJ-45 5 m marfil

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable (5 m, Ivory) is a shielded high-performance patch cable designed for reliable high-speed data transmission. It uses shielded twisted pair construction with individual foil and overall braid shielding to reduce electromagnetic interference and supports the Cat6a standard for up to 10 Gbps networks. Both ends are fitted with shielded RJ45 male connectors and molded boots with kink protection and strain relief, wired 1:1 according to EIA/TIA 568B.

Advantages

This cable combines SSTP shielding and AWG 26/7 twisted pairs to provide improved noise rejection and consistent signal quality over a 5 m run. The shielded RJ45 connectors and strain-relief boots reduce connector-related failures and help maintain stable connections in patch panels, wall outlets or device ports. Its Cat6a specification supports higher bandwidths and is backward compatible with Cat5e/Cat6 equipment.

Suitable for

• 10 Gbps local area network links up to 5 m
• Server racks and patch panels
• High-speed workstations, NAS devices and switches
• Environments with elevated EMI where additional shielding is required

Key specifications

• Cable type: SSTP (foil + full braid) shielded twisted pair
• Conductor: 4 pairs x 2 x AWG 26/7, twisted pair, 100 Ohm
• Connectors: 2 x shielded RJ45 male
• Wiring: 1:1 — EIA/TIA 568B
• Length: 5 m
• Color: Ivory

How to use

Insert each RJ45 plug into the corresponding Ethernet port until the connector latch clicks. Use the cable to connect network devices such as switches, routers, computers or patch panels. Route the cable to avoid tight bends; the molded boot with kink protection helps maintain the cable bend radius but avoid sharp angles to preserve performance.

Recommendations

For optimal performance, avoid running the cable parallel and close to high-voltage power lines or large electrical equipment. When installing in rack environments, use cable management to prevent excessive bending and tension. The Cat6a SSTP construction is recommended where 10 Gbps bandwidth and improved EMI protection are required.