Cable de red LOGON SSTP Cat6a RJ-45 RJ-45 5 m naranja

LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 5 m, in orange. The cable supports Cat6a performance with SSTP shielding (foil plus full braid) and four twisted pairs (4 x 2 x AWG 26/7) with 100 Ohm impedance. Fitted with two special shielded RJ45 male connectors and kink-protecting boots with strain relief; wired 1:1 to EIA/TIA 568B standard for straightforward endpoint connection.

Advantages

The SSTP construction (foil plus full braid) reduces electromagnetic interference for improved signal integrity over longer runs. AWG 26/7 twisted pairs and 100 Ohm characteristic impedance ensure compatibility with Cat6a performance and high-speed data transmission. Shielded RJ45 male connectors and strain-relief boots provide a secure, durable connection and help prevent cable damage at the plug.

Suitable for

• High-speed Ethernet links in office and home networks
• Horizontal and patch-panel connections requiring Cat6a performance
• Environments with potential electromagnetic interference

Key specifications

• Length: 5 m
• Cable type: SSTP Cat6a (foil + full braid)
• Conductors: 4 x 2 x AWG 26/7, twisted pair
• Impedance: 100 Ohm
• Connectors: 2 x shielded RJ45 male
• Wiring: 1:1 — EIA/TIA 568B
• Colour: Orange

How to use

Connect each RJ45 plug to the network ports of your devices or patch panels, observing the 1:1 EIA/TIA 568B wiring. Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid excessive tension; the boot with kink protection helps at the connector junctions.

Recommendations

For optimal performance, use this SSTP Cat6a cable in shielded or grounded installations when possible, and avoid running it parallel to high-voltage power lines. Test connections after installation to verify link speed and stability.