Cable de red LOGON TCF66F020Y Cat6a F/UTP (FTP) Amarillo 2 m RJ-45–RJ-45

LOGON TCF66F020Y is a 2 m Cat6a F/UTP (FTP) networking cable with shielded RJ‑45 connectors on both ends. Built for short patch connections in home, office or rack environments, this yellow cable follows EIA/TIA‑568 wiring and offers foil shielding to reduce electromagnetic interference for high‑speed Ethernet links. The cable uses four twisted pairs (AWG 26/7) and a PVC sheath for physical protection, providing a compact, ready‑to‑use Cat6a solution for shielded network runs.

Advantages

The foil shielding around the twisted pairs helps to lower crosstalk and external noise, improving signal integrity in electrically noisy environments. Shielded RJ‑45 plugs ensure continuity of the overall shield when used with compatible connectors and equipment. At 2 m length, the cable is suitable for short patching needs without excess slack, and the bright yellow jacket makes identification and cable management straightforward. The cable conforms to Cat6a transmission characteristics and EIA/TIA‑568 wiring, enabling reliable Gigabit and multi‑Gigabit Ethernet performance where a shielded patch cable is required.

Suitable for

• Short patch connections between switches, patch panels and wall outlets
• Home and small office Ethernet links requiring shielded cables
• Rack and server cabinet internal connections where reduced interference is needed
• Environments with nearby electrical equipment or cable bundles causing potential EMI

Key specifications

• Category: Cat6a F/UTP (FTP)
• Length: 2 m
• Conductor: 4 x 2, AWG 26/7, twisted pairs
• Characteristic impedance: 100 ohm
• Connectors: 2 x shielded RJ‑45 male
• Sheath material: PVC
• Color: Yellow
• Compliance: EIA/TIA‑568 wiring standard

How to use

Connect one RJ‑45 end to your network device (switch, router, patch panel or NIC) and the other end to the corresponding port. Ensure that connected equipment supports shielded cabling and that chassis or connector grounding is provided if full shield continuity is required. The cable is plug‑and‑play and requires no additional configuration beyond standard network setup. Avoid tight bends or pinching at the connector ends to preserve performance.

Recommendations

For optimal shielding performance, pair this F/UTP cable with shielded RJ‑45 ports and grounded patch panels or outlets. Keep the cable routed separately from unshielded power lines and maintain bend radii consistent with standard Ethernet cabling practice to preserve signal integrity.