Cable de red LOGON TCF66F150R — Cat6a F/UTP (FTP), RJ-45 a RJ-45, 15 m, rojo

LOGON TCF66F150R is a 15 m red Cat6a patch cable with F/UTP (FTP) shielding and RJ-45 male connectors on both ends. Designed for high-speed Ethernet links, this cable supports modern network installations where reduced electromagnetic interference and stable data transmission are important. The cable follows EIA/TIA 568 wiring standards and is supplied with a PVC outer sheath for everyday durability.

Advantages

The foil shielding around the twisted pairs improves resistance to external electromagnetic interference, helping to maintain signal integrity across the full 15 m length. Shielded RJ-45 connectors ensure secure contact and compatible grounding when used with shielded network equipment. The red PVC jacket makes cable routing and identification easier in multi-cable environments, while the plug-and-play design requires no additional tools or configuration.

Suitable for

• Data centers and server racks requiring reliable, shielded links
• Office networks connecting switches, routers and patch panels
• Home networks where higher performance and reduced interference are needed
• Structured cabling installations following EIA/TIA 568 guidelines

Key specifications

• Category: Cat6a F/UTP (FTP)
• Length: 15 m
• Connector type: RJ-45 male — RJ-45 male (shielded)
• Conductor configuration: 4 x 2, AWG 26/7, twisted pairs
• Characteristic impedance: 100 ohm
• Outer sheath: PVC
• Color: Red
• Compliance: EIA/TIA 568 wiring standard

How to use

Connect one RJ-45 plug to the Ethernet port of your switch, router or network device and the other RJ-45 plug to the corresponding port on the destination device. Ensure that shielded ports or patch panels are properly grounded when using the F/UTP cable to obtain the full benefit of the foil shielding. The cable is ready for immediate use without special configuration.

Recommendations

For optimal performance, avoid tight bends and sharp kinks; maintain the manufacturer’s minimum bend radius. Keep the cable away from strong sources of electromagnetic noise such as large motors or fluorescent ballast transformers if possible. When deploying in patch panels or shielded environments, verify proper grounding of connectors and chassis to reduce potential interference.