Cable de red LOGON TCF66F150V Cat6a F/UTP (FTP) RJ-45–RJ-45 Violeta 15 m

LOGON TCF66F150V Cat6a F/UTP (FTP) RJ-45–RJ-45 Violet 15 m is a shielded Category 6a patch cable designed for high-speed Ethernet and 10 Gigabit copper links. The cable features foil shielding around the pair group to reduce electromagnetic interference and crosstalk compared with unshielded alternatives. Terminated with shielded RJ-45 male connectors on both ends and supplied in an individual package, it is intended for structured cabling in offices, data centers and residential networks.

Advantages

The foil-shielded design enhances immunity to external noise and reduces near-end and far-end crosstalk, helping to maintain signal integrity for high-bandwidth applications. Constructed with four twisted pairs of 26 AWG stranded conductors and a 100 ohm characteristic impedance, the cable meets EIA/TIA-568 wiring standards. Shielded RJ-45 plugs and a PVC sheath provide reliable mechanical protection and straightforward plug-and-play installation without special tools for standard patching tasks.

Suitable for

• 10 Gigabit Ethernet links in short to medium runs
• Office and data center horizontal patching
• Home networking where reduced interference is required
• Connections between switches, patch panels and network devices

Key specifications

• Category: Cat6a (augmented)
• Shielding: F/UTP (foil around pairs, overall unshielded)
• Conductor: 4 x 2, stranded, 26 AWG (26/7)
• Characteristic impedance: 100 ohm
• Connectors: RJ-45 shielded male – RJ-45 shielded male
• Length: 15 m
• Sheath material: PVC
• Color: Violet
• Wiring standard: EIA/TIA-568 compatible

How to use

Connect the shielded RJ-45 plug to the network device or patch panel port and the other end to the corresponding port on the switch, router or device. Ensure proper grounding of shielded ports where available to achieve full benefit from the foil shielding. For best performance, avoid tight bending radii and running the cable parallel and close to high-voltage power lines; follow standard installation practices for Category 6a cabling.

Recommendations

Use this Cat6a F/UTP cable for short to medium-length links requiring reduced electromagnetic interference. When integrating with shielded infrastructure, verify that connector shields and chassis grounds are properly connected. Store and route the cable without sharp bends and within the recommended bend radius to preserve signal performance.