Cable de red LOGON TCF66F300R RJ-45 Cat6a 30 m Rojo

The LOGON TCF66F300R RJ-45 Cat6a 30 m Red networking cable is a 30-meter Cat6a-grade cable with F/UTP shielding and RJ-45 connectors on both ends. Designed to support high-speed data transmission and minimize electromagnetic interference, this red cable is intended for permanent or temporary network links in home, office, or data center environments. The cable’s Cat6a specification provides a higher bandwidth ceiling compared with earlier categories, while the F/UTP construction reduces outside noise for more stable signal integrity over longer runs.

Advantages

This LOGON Cat6a cable combines a long 30 m reach with foil-shielded twisted-pair construction to reduce crosstalk and external interference. RJ-45 terminations on both ends offer broad compatibility with standard network equipment. The red outer sheath improves visual identification in structured cabling installations and helps separate this run from other lines. Built to Cat6a performance characteristics, the cable supports demanding network applications that require consistent throughput and reduced error rates.

Suitable for

• Wired Ethernet connections between switches, routers and endpoints
• Office and home network installations where a 30 m reach is required
• Cabling runs that benefit from color-coded identification
• Environments where reduced electromagnetic interference is important

Key specifications

• Cable length: 30 m
• Cable category: Cat6a
• Shielding: F/UTP (foil shielded)
• Cable type: Crossover cable
• Connectors: RJ-45 to RJ-45
• Product colour: Red

How to use

Place the cable between the two networked devices, ensuring both ends are fully inserted into the RJ-45 ports until the connector latch clicks. Route the cable to avoid sharp bends, kinks, and proximity to high-voltage power lines to maintain signal quality. For permanent installations, secure the cable with appropriate clips or cable management hardware and leave service loops where necessary to allow for strain relief. Test the connection after installation using network diagnostic tools or a cable tester to confirm link integrity and performance.

Recommendations

Use the red LOGON Cat6a cable for mid-length runs up to 30 m where shielding against interference is beneficial. Avoid excessive bending radius and exposure to temperatures or mechanical stresses beyond normal indoor installation conditions. When connecting to equipment that requires a specific wiring convention, confirm crossover wiring compatibility or use additional patching to match the network topology.